Spectrum-controls 1734sc-OE2CIH Instrukcja Użytkownika Pobierz pdf (Strona 19)

Chapter 2: Installation and Wiring 2-5

User’s Manual Pub. 0300272-01 Rev. A.0

2.4.2 Install Mounting Base

WARNING

Hazard of damage to module on power up.

Debris that falls into the module could cause damage when

power is applied to the module.

During panel or DIN rail mounting of all devices, be sure that all

debris (such as metal chips or wire strands) is kept from falling into

the module.

To install the mounting base on the DIN rail, proceed as follows:

1. Position the mounting base vertically above the installed units (adapter power

supply or existing module).

2. Slide the mounting base down allowing the interlocking side pieces to engage

the adjacent module or adapter.

3. Press firmly to seat the mounting base on the DIN rail. The mounting base will

snap into place.

4. To remove the mounting base from the DIN rail, remove the module, and use a

small-bladed screwdriver to rotate the base locking screw to a vertical position.

This releases the locking mechanism. Then lift straight up to remove.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 73 74

Brak uwag

Spectrum-controls 1734sc-OE2CIH Instrukcja Użytkownika Strona 19