Spectrum-controls 140 MPM 204 00sc Instrukcja Użytkownika Pobierz pdf (Strona 56)

Quantum Series 140 MPM 204 00sc

Active LED Does Not IlluminateActive LED Does Not Illuminate

Active LED Does Not Illuminate

Possible CausesPossible Causes

Possible Causes

The module is not communicating with the PLC rack.

CorrCorr

Corr

ective ective

ective

ActionAction

Action

1.1.

1. Deinstall the module. See chapter 2, “Installation and Wiring.”

2.2.

2. Place the rack in run mode.

3.3.

3. Reinstall the module in the rack. See chapter 2, “Installation and Wiring.”

Fault LED Does Not IlluminateFault LED Does Not Illuminate

Fault LED Does Not Illuminate

Possible CausesPossible Causes

Possible Causes

• Module self-test error

• Fatal hardware error

CorrCorr

Corr

ective ective

ective

ActionAction

Action

Contact your local distributor.

Fault LED Blinking RedFault LED Blinking Red

Fault LED Blinking Red

Possible CausesPossible Causes

Possible Causes

Type of self-test error. Possible codes are indicated in the Diagnostic LEDs section of chapter 1, “Overview.”

CorrCorr

Corr

ective ective

ective

ActionAction

Action

Verify module configuration information.

No Signal IndicationNo Signal Indication

No Signal Indication

There is no indication of a signal in the input register count rate word. If status bit 3x+1 - 3x+8 (Bit 14)

(counter input state) is high and status bit 4 (rate zero) is high.

Possible CausesPossible Causes

Possible Causes

If you have an open collector output or a relay or contact type output, you might require a 1 to10 kohm pull-

up / pull-down resistor.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 65 66

Komentarze do niniejszej Instrukcji

Brak uwag

Spectrum-controls 140 MPM 204 00sc Instrukcja Użytkownika Strona 56

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Spectrum-controls 140 MPM 204 00sc